Robin EH17-2D - Stopping the Engine; Stopping Procedure

STOPPING
Set the speed control lever at the
low speed position and allow the
engine to run at low speed for 2
or 3 minutes before stopping.
Turn the STOP SWITCH counter¬
clockwise to the position "O"
(OFF).
KEY SWITCH H
(OPTIONAL)
. Set the key switch to "0“ (STOP) I
position. |
V- -
Close the fuel cock.
Pull the starter handle slowly and
return the handle to its original posi¬
tion when resistance is felt.
NOTE:
The above operation is necessary to
prevent outside moist air from intrud¬
ing into the combustion chamber.
---
- 10 -