Normal and prohibited use
The machine is designed for the following work and is equiped with protective
devices for these processes only.
It is not designed to work materials such as ferrous and non-ferrous metals, work
different from that stated below is prohibited.
NORMAL USE
- thicknessing on the thicknesser unit;
PROHIBITED USE
- the use of other materials than wood, such as ferrous or non-ferrous materials.
REMAINING RISKS
- unintentional contact of the hands with the running cutter block;
- workpiece kickback;
- tipping over of the workpiece due to insufficient support;
- ejection of knots, ect.
The above does not negate the fact that extra safety equipment such as safety gloves
and ear protection must be used.
To Next Page
Loading...
