Roboguard 21
Roboguard Remote TX
For use with Roboguard Receivers
All remotes have unique codes in all four of the coloured buttons
To programme the remote into your receiver, follow the instructions in
the receiver user manual.
TO CLONE A REMOTE:
Hold down the button on the slave remote. Keep holding this button
down until programming is completed.
When the light switches off the slave is ready to be taught the code
from the master remote.
Position the master remote as close to the slave remote as possible.
(Key ring to key ring)
Push the corresponding button on the master remote until the light
goes off on the master.
The light will flash continuously on the slave remote once programming
is successful.
You can now stop pressing both buttons.
Continue with the next button as above.
The unit is ready to be tested
For maximum transmission hold down the remote button until the LED
switches off.
Specifications:
Transmit Frequency: 433.92 MHz
Encryption: 24bit Roboguard protocol
Battery type: Gp23a 12V
Model Number: TRX005
To Next Page