Roboguard 6
SWITCH 4: SKINNY WINDOW MODE
OFF = Roboguard will respond to vertical movement through the
beams. It allows a second between breaking top and bottom beams
to detect intruder.
ON = This mode reduces that tolerance to a second thus allowing
slow moving branches to break both beams without detecting intruder.
Not good for range over 10 metres.
SWITCH 5: DSP MODE
OFF = Normal
ON = The guard will use a mathematical algorithm to determine
whether an intruder has been spotted and helps to minimise false
alarms. It is usually used in industrial applications to filter out
electromagnetic energy from electronic/radio equipment.
Beam Range
The two-way switch box (see picture - above) determines beam range
and can be adjusted as follows:
Full Range (default) Switch 1: OFF, Switch 2: OFF
15 - 20 meter range Switch 1: ON, Switch 2: OFF
10-15 meter range Switch 1: ON, Switch 2: ON
NOTE: Full strength in a small area may cause false alarms.
Adjustments should be made to both top and bottom sensor
boxes.
To Next Page
Loading...