51
Are there any Separated Zones?
For lawns that have completely noncontiguous Separated
Zones, the area size of these zones needs to be set separately.
To do this, press “Settings” on the mower’s panel for more
than 3 seconds. Scroll to get to the menu P014.
The table below describes how to use this menu to program
a Separated Zone:
Splicing the Perimeter Wire
(as needed)
• Insert both wire ends into
the leftmost and rightmost
positions on the connector.
• Verify that the wires are fully
inserted into the connector.
• Use a pair of pliers to press
the button on top of the
connector. The button should
be fully pressed, without
damaging the connector.
Screen Setting Description
P014
Add Separated
Zone
• Enables to add of a Separated Zone.
• L2 is displayed for Separated Zone A – press OK.
• Scroll to set the area of the Separated Zone and press OK.
A helpful video
is available
online
To Next Page
Loading...
