06
C9
Drying
Drying starts automatically after self-
cleaning is completed. To manually start
or stop drying, press the
button on the
docked vacuum cleaner.
Routine Maintenance
D
To maintain optimal performance of the
product, refer to the following table for
routine maintenance.
Parts
Maintenance
Frequency
Replacement
Frequency
Roller 2–4 weeks 6–12 months
Filter 1 month 6–12 months
Voice Alert Settings
Connect to the app to adjust the volume of
voice alerts.
Notes:
• The product is equipped with a built-in high-
performance lithium-ion rechargeable battery pack.
To maintain battery performance, keep the product
charged for normal use.
• Self-cleaning can only be used when the vacuum
cleaner is charging and the battery level is ≥20%. Do
not lift the vacuum cleaner during the self-cleaning
process.
• Always place the vacuum cleaner on the charging
dock after use to prevent water stains.
1. Lock the cleaning head, and place the
vacuum cleaner onto the charging dock.
The voice alert "Start Charging" indicates
that the vacuum cleaner is charging.
2. Press the
button on the top of the
handle to start self-cleaning using hot
water. Press and hold the
button for 2
seconds to switch to DEEP self-cleaning
mode using hot water. Alternatively, set
the self-cleaning type to self-cleaning
using water at room temperature or self-
cleaning using warm water in the app.
3. After self-cleaning finishes, empty the
dirty tank to prevent odors.
C7–3— Reinstall the cover, tilt the dirty tank,
install the bottom in place, and then
gently push the tank inward until it
clicks in place.
C8
Charging and Self-Cleaning
C7–1— Hold the body of the dirty tank
with one hand, push the dirty tank
release with another hand, and then
remove the tank.
C7
Emptying the Dirty Tank
C7–2— Gently lift out the handle of the
cover to remove it, and then pour
out the dirty water.
is empty during use, the vacuum cleaner
will provide audio and visual alerts. Add
water into the clean tank or empty the dirty
tank before continuing.
Parts
Maintenance
Frequency
Replacement
Frequency
Cleaning head
and dirty water
pipe
1 month N/A
Dirty tank 1 month N/A
Charging dock As needed N/A
Charging
contacts
1 month N/A
Roller cover 2–4 weeks N/A
You can use the Roborock app to stop the
automatic drying that initiates after the self-cleaning
process.
Product Maintenance
Wipe and clean the vacuum cleaner with a
soft and dry cloth. Before cleaning, remove
the vacuum cleaner from the charging dock
and switch it off.
Cleaning the Vacuum Cleaner
If this product is left unused for a
prolonged period of time, fully charge it and
unplug it before storing it in a cool and dry
place. Do not place the product in humid
locations or under direct sunlight. Charge
it at least once every 3 months to avoid
overdischarge.
D1
Cleaning the Dirty Tank and
Filter
The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
Note:
Note:
To Next Page
Loading...
