07
D1–1—Take out the dirty tank, pull out the
cover, and take out the filter from the
cover. Remove any trash attached
to the filter using the provided
maintenance brush. If the filter is
dirty, rinse it with cold water and
then shake off the residual water.
• Use the maintenance brush carefully to avoid injury.
• Before you clean the roller, make sure that the
vacuum cleaner is switched off or in upright and
locked position.
Notes:
D2–1—
D2–2—
D2–3—
D2–4—
Press the release buttons on both
sides of the cover simultaneously
and lift the cover upwards to detach
it.
Unplug the charging dock and use a soft
dry cloth to clean the surface and charging
contacts of the charging dock.
Press the buttons on one side of the
roller and pull the roller out from
the side. Remove any dirt attached
to the roller using the provided
maintenance brush, and rinse it with
clean water.
Rinse the detached roller cover with
clean water.
Reinstall the roller and roller cover in
the correct order.
D2
Cleaning the Roller and
Roller Cover
D3
Cleaning the Cleaning Head
and Dirty Water Pipe
D4
Cleaning the Charging Dock
Do not wash the cleaning head directly with water.
Do not rinse the charging dock directly with
water.
Note:
Note:
Notes:
• Use a second filter if necessary.
• Do not touch the filter with your hands, brushes, or
sharp objects to avoid damage to the filter.
D1–2—Dry all parts thoroughly before
installing them back in place.
1. Switch off the vacuum cleaner and
stabilize the body. Remove the dirty tank,
roller cover, and roller.
2. Clean the roller slot and dirty water pipe
with the provided maintenance brush.
3. Reinstall the roller, roller cover, and dirty
tank in place.
Basic Parameters
Vacuum Cleaner
Dock Charger
Service WiFi
Protocol 802.11b/g/n
Frequency
Range
2400-2483.5 MHz
Max. Output
Power
≤20dBm
WiFi Specification
Model WD3D2A
Rated Input 25.6VDC 1A
Battery
21.6 V/4000 mAh (TYP)
Lithium-ion battery
Model MDS10HRR
Rated Input
Voltage
220-240VAC
Rated
Frequency
50-60Hz
Rated Input
(Hot water
washing mop)
6A
Rated Input
(Charging &
drying)
0.8A
Rated Output 25.6VDC 1A
Charging
Battery
21.6 V/4000 mAh
(TYP) Lithium-ion
battery
To Next Page
Loading...
