EasyManua.ls Logo

Roborock Q5 DuoRoller+ - Page 11

Roborock Q5 DuoRoller+
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Clean the main wheels with a soft, dry cloth.
*
Clean as required.
C4
Main Wheels
C5
Dustbin and Washable Filter
* Clean every week and filter should be replaced every
6-12 months.
Note: To prevent blockage, only use clean water without
any cleaning liquid.
Note: Purchase an additional filter and alternate if
necessary.
Note: Do not touch the surface of the filter with your
hands, brush, or hard objects to avoid potential damage.
C5-1—
Press the dustbin latch and slide the
dustbin backwards.
C5-2—
Remove the washable filter and empty
the dustbin.
C5-3—
Fill the dustbin with clean water.
Gently shake the dustbin, and then
pour out the dirty water.
C5-4—
Rinse the washable filter repeatedly
and tap it to remove as much dirt as
possible.
C5-5—
Allow at least 24 hours for the
dustbin and washable filter to dry
thoroughly before reinstalling them.
C8
Air Duct
*
Clean as required.
C8-1—Unscrew the screws (10) and remove
the cover.
C7
Dust Bag Replacement
*
Replace as required.
Note: The dust bag handle seals the bag on removal to
prevent dust leakage.
C7-1—Remove the dustbin cover vertically
as shown.
C7-2— Lift the dust bag out of the dustbin
and discard it.
C7-3— Clean the filter with a dry cloth.
C7-4—Install a new dust bag in place along
the slot and put the dustbin cover
back.
C8-2—Wipe the air duct and cover with a
dry cloth.
C8-3—Reinstall the cover and screw it back
in place.
C6
Robot Sensors
* Clean as required.
C6-1—Dock Locator
C6-2—Wall Sensor
C6-3—Four Cliff Sensors
Use a soft, dry cloth to wipe all sensors,
including:
Use a soft, dry cloth to wipe the charging
contacts on the robot. Clean the dock
location beacon, charging contacts, and
electrode brushes on the dock.
C9
Charging Contacts
*
Clean as required.
The robot is equipped with a high-
performance lithium-ion rechargeable
Battery
Note: If the robot will be left unused for a long period,
turn it off and charge it at least every three months to
avoid battery damage caused by over-discharge.
battery pack. To maintain battery
performance, keep the robot charged
during normal use.

Related product manuals