26
Environmental protection description
Removing the battery
The chemical substances contained in the built-in lithium-ion battery of this product can cause environmental pollution. Remove
the battery before disposing of this product and hand it to a professional battery recycling facility for centralized disposal.
1. Operate the robot until it has low battery and is unable to clean, ensuring it does not connect to the charging dock.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the clip to pull out the battery connector and remove the battery.
Note:
•
Before removing the battery, make sure it is fully drained. Do not attempt to remove the battery if the robot is connected to the charging dock.
•
Remove the entire battery pack. Avoid damaging the battery pack casing to avoid short-circuits or leakage of hazardous substances.
•
In the event of accidental contact with battery fluid, rinse thoroughly with water and seek immediate medical care.
The following information applies only when disposing of the robot and should not be followed for day-to-day operations
*
To Next Page
Loading...
Need help?
General
