17
Pin n Go
Use the app to set a destination for the robot to go to.
Cleaning mode
Use the app to choose from Quiet, Balanced, Strong, or MAX
modes. The balanced mode is the default.
Do Not Disturb (DND) mode
In DND mode, no cleanups will start, no voice alerts will play,
and the power indicator will dim. DND mode set from 22:00
to 08:00 by default and can be disabled or modified in the
app.
Virtual no-go zones and walls
The app can be used to draw Virtual No-Go Zones and Walls
to keep the robot from entering the areas you define.
Note:
• "Map Saving Mode" must be turned on in the app to use virtual no-go zones.
• Virtual no-go zones and walls should only be used to customize the cleaning area.
They should not be used to isolate hazards.
• Moving the robot manually or making significant changes to the home
environment may cause the loss of virtual no-go zones and walls.
More app functions
Real-time map updates Carpet Boost Robot location
Change cleaning mode Part replacement schedule Do Not Disturb (DND) mode
View cleaning history Remote control Firmware update
Change robot voice View robot status
Note:
Functions and details of the app may vary slightly due to continuous app
development and upgrades.
Refilling the water tank or cleaning the
mop cloth mid-clean
To refill the water tank or clean the mop cloth during a
cleanup, pause cleaning by pressing any button and remove
the mop module. Refill the water tank and/or clean the mop
cloth as required. Reinstall the mop module and press the
button to continue cleaning.
Instructions for Use
Walls
No-Go Zones
To Next Page
Loading...
Need help?
General
