Name: Roborock S6 Pure
Brand: Roborock
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Routine maintenance

Wheel

Axle

Bracket

Cli sensor

Omnidirectional wheel

Charging contact

Side brush

Wall sensor

Note:

The omnidirectional wheel bracket cannot be removed.

System Reset

If the robot does not respond when you press a button or

the robot cannot be shut down, press the Reset button .

The robot will then restart.

Note:

Aer a system reset, cleaning schedules, WiFi and other settings will be restored to

factory settings.

Restore factory settings

If the robot is not functioning aer a system reset, turn it on,

then press the button, and then press and hold the Reset

button until you hear the "Start restoring initial version"

voice alert. The robot will then be restored to factory

settings.

Robot sensors

*Clean monthly

Use a so dry cloth to wipe and clean all sensors, including:

1. Four cli sensors at the bottom of the robot.

2. The wall sensor on the right of the robot.

3. The charging contact on the bottom of the robot.

Firmware update

Update the robot using the app. Place the robot on the

charging dock and ensure that the battery level is higher

than 20% before updating. The power indicator will flash

white quickly during a firmware update.

Other manuals for Roborock S6 Pure

Questions and Answers:

Need help?

Do you have a question about the Roborock S6 Pure and is the answer not in the manual?

General