3. Support reading some default ECU parameters, such as SN, PS, and PL version
4. Support bin and hex firmware format flashing
5. Support Reset function (LiDAR soft-reboot function)
C.3.2 Interface Description
A license is required for the first-time running the software. As shown in Figure 2. Please use
the following license serial number:
Figure C - 2: RoboSense License Notice
After entering the License Serial Number, check [I Agree], and click [Auth] to enter the tool
operation interface, as shown in Figure 3.
Figure C - 3: Operation initial interface (Unlink mode)
To Next Page
Loading...