To Next Page
I
igorDec 19, 2025
electrical diagrams press brake ATC 560
electrical diagrams press brake ATC 560
Describes the operation of the 3-position switch for controlling the beam movement.
Details the function and reset procedure for the emergency-stop button.
Provides step-by-step instructions for powering on the machine and control.
Guides the user through the process of establishing machine reference points.
Explains the procedure to restart the machine after an emergency stop event.
Details the normal work-mode for manual positioning of axes and bending operations.
Explains how to program the back-gauge by entering target values.
Step-by-step instructions on how to perform a bending operation.
Describes the parameter mode, intended for qualified personnel for system setup.
Explains calibrating axes by entering preset values for references.
Introduces programming capabilities for the press-brake, including steps and programs.
Step-by-step guide on how to create and program new sequences.
Instructions on modifying previously created programs.
Details how to execute stored programs automatically.
Provides a list and explanations of error codes displayed by the control system.
General| Category | Press Brake |
|---|---|
| Bending Length | 2550 mm |
| Throat Depth | 250 mm |
| Stroke Length | 120 mm |
| Working Speed | 10 mm/s |
| Back Gauge Stroke | 500 mm |
| Power Supply | 380V, 50Hz |