6
16/11/2021
WARNING: In order to limit accidents such as electric shocks, personal injury or fire, and in order to limit material damage due to misuse of the appliance, please read
these instructions carefully and follow them strictly. Reading the operating instructions will help you get to know your appliance and enable you to use the equipment
correctly. The operation manual should be kept within easy access to all users for reference and should be read completely by all first time users of the machine. Our
equipment is designed for professional use and must not be used by children under any circumstances.
UNPACKING
• Carefully remove the equipment from the packaging
and take out all the boxes or packets containing
attachments or specific items.
• CAUTION: Some of the parts are very sharp, e.g.
cutting blade. Always handle with safety in mind.
INSTALLATION
• The machine must be operated on a clean sturdy
counter or table. Keep the area around and under the
machine clear to allow air circulation. Otherwise, the
motor can overheat.
CONNECTION
• Always check that your power supply corresponds to
that indicated on the serial number plate and that it is
properly sized.
NOTICE : DRIVE SHAFT ROTATION
• Three phase motors may rotate either direction.
• The required motor rotation is counter-
clockwise.
• Changing the motor rotation requires a
qualified electrician.
• See note on end of power cord.
HANDLING
• Always take care when handling the blades, as they are
extremely sharp.
ASSEMBLY PROCEDURES
• Follow the various assembly procedures carefully (see
page 8) and make sure that all the attachments are
correctly positioned.
USE
• The machine must not be modified in any way from
its original configuration.
• Operating times of 5 minutes or longer can cause
processed food to increase to temperatures above
125° F (52° C).
• Never tamper with, or defeat the purpose of the
locking and safety systems.
• Do not put nonfood objects in the bowl.
• Do not leave the machine running unattended.
• The machine must be operated and stored in a location
not subject to water drips or spray or explosive vapors.
• Should the machine malfunction or should any part
be damaged, it must not be operated until it is repaired
by a qualified technician using only genuine Robot
Coupe repair parts.
• Failure to follow these operating instructions or
attempts to operate the machine outside its design
limits may create a hazardous condition that could
damage the machine and/or injure users. Special
attention should be given to the use of the operation
controls and safety features.
• The unit is equipped with a thermal overload circuit-
breaker. If the unit overheats due to an overload
condition, it will automatically shut off. After cooling a
few minutes the thermal overload circuit-breaker may
be reset. Press the reset button located on the bottom
left front of the unit.
CLEANING
• Always disconnect the machine from the power outlet
when not in use and when cleaning or servicing the
unit.
• Always clean the machine and attachments at the
end of each use.
• Never place the motor unit in water.
• For parts made of aluminum alloys, use cleaning
detergents suitable for aluminum.
• For plastic parts, do not use detergents that are too
alkaline (i.e., containing too much caustic soda or
ammonia…).
• Robot Coupe can in no way be held responsible for
the user’s failure to follow the basic rules of cleaning
and maintenance.
MAINTENANCE
• Always disconnect the machine from the power outlet
before servicing the unit.
• Check the seals regularly and ensure that the safety
devices are in good working order.
• NOTICE: Never operate the appliance if the power
cord or plug has been damaged.
• If the machine fails to operate as described in this
manual, or if the machine malfunctions in any way,
remove the machine from use and have it serviced.
Additionally, discard all food processed at the time of
the malfunction.
• Contact your local Authorized Service Agency if
something appears to be wrong.
IMPORTANT WARNING
WARNING
KEEP THESE INSTRUCTIONS IN A SAFE PLACE
To Next Page
Loading...
