ROBOT3T THC3T-02 - Parameter Setup

ROBOT3T- 3C MACHINERY CO., LTD
6/4, 328 Cao Lo Street, Ward 4, District 8, Hochiminh City, Vietnam
Email: sales@robot3t.com
(+84) 97-490-8615
USER MANUAL THC3T-02 UP/DOWN Page 12 | 21
3. Setup parameters
Press the “menu” button to choice mode need to set:
Table2. Parameters on LED display
No
Mode
Value
Description
1
U
Set-height
U10 to U300
To set height from torch to material in
auto mode by the potentiometer.
factory setting: U=150
2
A
Area for control
A001 to A075
Device will change to auto mode when
the arc voltage from:
[Voltage Set - Area for control] to
[Voltage Set + Area for control]
factory setting: A=75
3
S
Sensitive
S100 to S800
This parameter determines the value
respond of Z axis motion.
factory setting: S=50
4
P
Arc-voltage
P000 to P300
Display the arc voltage value from
plasma cutter.
5
d
Delay time
d001 to d099
The delay time to send ARC_OK from
0.1 to 9.9s: THC will sent ARC_OK
signal after this delay, the main purpose
is Z axis not move down at the first time
of cutting.
factory setting: d=10 (1s)
6
v
steady-state
error
v001 to v099
The steady-state error a range in which
the voltage is set errored, in which there
are signals controlling UP/DOWN
v =0.1-9.9V (±0.1V -> ±9.9V),
factory setting: v = 3.0V (±3.0V)