Robotex AVATAR III - Robot Not Powering On

 


25

Avatar®IIIUserManualRevD12/2015

robotwhileitispluggedintoanexternalpowersource.Iftheproblempersists,
callourCustomerSupportline.


F. Therobotdoesnotpoweronwhenabatteryisinstalled.

1:Checktoseethatthebatteryisnotcompletelydischarged.

2:Besurethattheconnectionsonthebatteryarecleanandthatthe
correspondingconnectionsontherobotareclean.

3:Iftherobotorbatteryiswetwhenthebatteryisinserted,watermaygetinto
thebatteryconnectorandpreventtherobotfrompoweringup.Usecanned
compressedairorahairdryertodrytheconnectorsonthebatteryandthe
correspondingconnectorontherobot.Itmaybenecessarytolettherobotdryfor
24‐48hoursbeforeattemptingtousetherobotagain.

4:Checktheredpowerbuttonontheleftsideoftherobot.Itshouldmovefreely.
Ifitdoesnotmoveoritisjammed,trymovingthemetalshroudthatcoversthe
coolingfanbyhand.Itmaybenecessarytoremovethemetalshroudandclean
anydirtordebrisfromaroundtheredbutton.Iftheproblempersists,callour
CustomerSupportline.