Direct Digital Controller
50 Direct Digital Controller fw 4.013 – Ed. 01/2013
3.4.2.5 Display Options
This option allows the user to adjust the contrast of the graphic display.
To adjust the contrast:
1. Position the cursor on the contrast level.
2. Press the knob. The number starts to flash.
3. Turn the knob to modify the value.
4. Press the knob to confirm the contrast level chosen.
5. Select "Lighting always On” and the backlighting stays on, otherwise
it will switch of after 15 minutes of Encoder inactivity.
To exit, select
.
3.4.2.6 User Password Setup
This option allows the user to set/disable the user password.
To set the user password, follow the instructions below:
1 - Select
from the initial screen to gain access to the main menu.
2 - Select
to access the “User settings” menu.
3 - Select “Preferences” from the drop-down menu.
4 - Select “Set user password” from the drop-down menu.
5 - Enter the password requested and select to confirm.
6 - Enter the new password again and select
to confirm.
Once the password has been enabled, it must be entered every time it is necessary to access the “User
settings” menu (
).
Each time the password is entered to access the User settings menu, it remains active for 10 minutes after
exiting from the menu.
Instructions for modifying or disabling the user password follow.
1 - Select
from the initial screen to gain access to the main menu.
2 - Select
to access the “User settings” menu.
3 - If requested, enter the user password on the numerical keypad that appears on the display.
4 - Select “Preferences” from the drop-down menu.
5 - Select “Set user password” from the drop-down menu.
6 - If a user password is present, a numerical keypad appears on the screen. Enter the old password via this
keypad and then select
to confirm it.
7 - The screen asks for the new password to be entered; enter it and select
.
To Next Page
Loading...