Robustel GoRugged R3000 Wireline - Page 40

Robustel GoRugged R3000 Wireline - 4 Ethernet Ports User Guide
RT_UG_R3000 Wireline- 4 Ethernet Ports _v.1.1.0 02.07.2015 39 / 116
Confidential
Status @ WiFi
BSSID
Show MAC address of R3000 Wireline’s WiFi interface or the access
point which R3000 Wireline connects to.
Null
SSID
Show SSID of R3000 Wireline’s WiFi interface or the access point which
R3000 Wireline connects to.
Null
Mode
Show current mode of R3000 Wireline: AP or Client.
Null
Key Management
Show current security mode of R3000 Wireline or the access point
which R3000 Wireline connects to.
Null
Cipher Pairwise
Show current encryption algorithm of R3000 Wireline or the access
point which R3000 Wireline connects to.
Null
Cipher Group
WPA State
Show current WPA status. Mainly there are 5 statuses: Disconnected,
Scanning, Initializing, Associated, 4way_handshark, Completed.
Disconnected: Not associated or connected with any access point,
perhaps because the wireless device has not fully initialized, is out of
range, or the wireless interface is disconnected because the Ethernet
interface is enabled.
Scanning: Searching for a wireless network (access point) for
connection.
Initializing: R3000 Wireline is setting up initial wireless environment.
Associated: This state is entered when the driver reports that
association has been successfully completed with an AP, but still waiting
for authentication.
4way_handshark: This state is entered when WPA/WPA2 4-Way
Handshake is started. When Passphrase do not match, it will show this
status.
Completed: The wireless connection of R3000 Wireline and other
wireless devices are established.
Null