2013 年 11 月 01 日
Automatic identification of entrance guard.
Set motion detection protection.
Details please check alarm set.
Chapter 6 Common questions
Q: Forget user name and password
A: Reset the camera, the user name and password is the value of restored
factory settings. user:admin password is blank. Please connect with
electricity before reset, then long press the reset button for 30 seconds to
reach reset the camera.
Q: Unable to connect with WIFI?
A: Usually,if camera is unable to connect with WIFI, it is because of wrong
set. please check it as following points
1) When use scan button, Can the camera search wireless signal of router?
2) Is SSID conformed with router wireless SSID?
3) Is wireless SSID and WIFI password set with specific symbol, if yes,
please revise it.
4) Is wireless mac add filtering turned on?
5) Is APR binding turned on?Camera wireless and network cable have two
different mac addresses but the same IP).
6) The camera is too far away from router? Normally please keep the
distance in 20M indoor.
7) The antenna is tightened?
Q:IP camera install wizard can’t find the IP?
To Next Page
Loading...