Roche ACCU-CHEK - Setting the Meter Time and Date

12
Your New System
1
Press and hold until set-up
appears on the display. The
hour flashes.
Press
or to decrease or
increase the hour.
Press and release to turn
the meter on.
The flashing test strip symbol
appears on the display.
2
set-up
Press to set the hour and
move to the next field.
Repeat steps 2 and 3 to set
minutes, am or pm, month, day,
and year. Press and hold
until the flashing test strip
symbol appears. Insert a test
strip to perform a test.
3
4
1
Setting the Time and Date
NOTE
• The meter prompts you to set the time and date the first time you
turn the meter on or if an error occurs.
• Press and hold
at any time until the flashing test strip symbol
appears to perform a test.
• The time and date on the meter synchronizes to the time and
date on the paired device each time the meter sends data to the
paired device.
set-up
81265_08500142002_EN_Insides.indb 12 10/28/2019 1:54:56 PM