76 Rocket Model 204 Terminal User’s Guide
Teletype terminals (IODEV = 39, ALTIODEV = 45)
Parameters
The parameters listed in Table 6-4 apply to Teletypes and compatible devices
being used through CMS.
These parameters can be reset using the RESET command. The settings of
INMRL, INCCC, OUTMRL, and OUTCCC cannot exceed 132. If a larger value
is specified, it is automatically changed to 132.
Page header formats
HDRCTL consists of a series of switches that control the formatting of pages
transmitted to the terminal. Each switch can be set independently of the others.
HDRCTL can be reset to the following values for Teletypes and compatible
terminals:
TERMOPT consists of a series of switches that can be set independently and
can be reset to the following values for Teletypes and compatible terminals:
Table 6-4. Screen-formatting parameters for CMS Teletypes
Parameter Meaning Default
INMRL Maximum input line length for terminal 80
INCCC Input continuation column 72
OUTMRL Maximum output line length for terminal 132
OUTCCC Output continuation column 132
OUTLPP Number of lines per page, including headers and
trailers
56
PGSEP Number of lines between output pages 2
HDRCTL Page formatting options 0
TERMOPT Terminal options 0
0 Normal headers (system header showing date, time, and page number)
1 Suppress header 0 (system header showing date, time, and page number)
2 Suppress the blank line that normally follows header 0 for nonrequest
output
4 Pause at the end of an output page; add a line to each page, in addition to
OUTLPP plus PGSEP, to receive a reply.
0 Terminal is hard copy (not CRT); no backpaging.
2 Terminal is soft copy (CRT); save and display backpages.
To Next Page
Loading...