10
Sender back panel
Note: When four-channel lock is enabled, other Rocketboost receivers in your
network are not able to select the audio source from the four channels. This is by
design, as most people would not want to listen to surround sound audio sources in
other rooms besides the home theater. If you want other receivers to select the four
channel audio source, disable the four-channel lock.
# Feature Description
1
DC IN jack
Plug the AC power adapter into this jack.
2 & 4
SPEAKER IN A/B
Use for an amplified output such as that from a receiver or other home theater
system. Connect these inputs to your audio source's speaker out jacks just like you
would connect passive speakers.
3
Pre-in A/B jack
Use for line level audio applications such as music output from an MP3 player or DVD
player. These devices typically have either a 3.5 mm connector or RCA jacks. Adapters
for both are included in the kit.
5
Hub Enable
switch
Set switch to Enable for hub operation. Set switch to Disable to disable hub
operation.
Note: There should be only one hub in a network. Read “Establishing
communication” on page 25 for more information.
Set to Disable if you already have a working Rocketboost network, because a
Rocketboost device is already set as the hub.
6
4-channel lock
switch
Set to Enable to synchronize the volume levels of inputs A and B, allowing 7.1
surround sound systems to optimize speaker volume levels.
Set to Disable to allow separate control of the volume levels for Inputs A and B.
1
5
4
2
3
6
RF-RBKIT_10-1157_MAN_V4.fm Page 10 Friday, October 8, 2010 12:53 PM
To Next Page
Loading...
Need help?
General
