22
Make sure that you connect your amplifier using the speaker output terminals.
Make sure that the amplifier volume is not set to zero, or no sound will be
transmitted.
Connecting to the Pre-in connectors (for MP3 player or CD
player type connections)
Caution: Turn off your audio source while connecting the devices.
To connect the sender to an external audio source:
1 Connect external audio source(s) to the Pre-in A and/or B jacks on the rear
of the sender using the 3.5 mm stereo cable. If necessary, you can also
use the 3.5 mm to RCA adapter, if your audio device uses RCA type line
out connectors.
• When your audio source is connected to the Pre-in A/B jack of the
sender, the corresponding Speaker Input A/B terminals are not used.
After the 3.5 mm audio cable is removed from the sender, the input
type switches back to the Speaker Input A/B, automatically.
• If you leave the 3.5 mm audio cable connected to the Pre-in A/B jack,
you can switch the audio source from the Speaker Input A/B terminals
by using the remote control INPUT A or INPUT B buttons.
Note: For best audio quality, make sure that the volume setting on the audio source
connected to the Pre-In jacks is turned up to at least 80%.
Sender back
To headphones or
line out audio jacks of
your TV, DVD, MP3, or
other audio source
component.
RF-RBKIT_10-1157_MAN_V4.fm Page 22 Friday, October 8, 2010 12:53 PM
To Next Page
Loading...
Need help?
General
