24
5 Adjust the audio level on the Rocketfish receiver so that the volume
range is proportional to your other AV receiver channels.
Activating high definition audio
The system is capable of driving high definition audio to your
multi-channel surround home theater system and remote listening
zones.
To activate the high definition audio:
• Press the HD A/B button to activate HD audio on the appropriate input
channel.
• The corresponding HD A or B indicator lights blue.
• The HD indicator on the joined receiver lights up.
• Only activate high definition audio when using the high definition
disks (such as Blu-ray disk).
Adjusting the volume balance
The volume control on the receiver is only used to adjust the volume
balance between the front and surround speakers. After the system is
set up, we recommend that you adjust the volume balance one time.
Note: After the receiver volume is set, always adjust the volume using the remote
control or volume buttons on your amplifier or external audio device.
Optimizing your surround sound
Wireless links create a small latency between the sender and receiver,
and many A/V receivers let you adjust the delay between the various
speakers in your surround system.
To optimize your system, we suggest that you subtract about 15 ms
from the delay to the surround speakers, this will perfectly match
your surround system.
Disabling an audio channel
To disable an audio channel:
• Press the SOURCE A/B button on the sender to stop the audio signals from
being transmitted from either input A or B.
RF-RBKIT_09-0473_MAN_ENG_V1.fm Page 24 Thursday, August 27, 2009 6:44 PM
To Next Page
Loading...
Need help?
General
