15
RF-WHP212
Notes:
If the charge on the headphone batteries is low, the
POWER/PAIRING indicator on the headphones blinks red.
When this happens, you should charge the headphones. For
instructions, see “Charging the headphones“ on page 13.
Tip: If the power indicators on the headphones and docking
station continue to blink after 30 seconds, they are no longer
paired to each other. If this happens, follow these steps:
• Make sure the heaphones and docking station are within
range of each other (ideally in the same room).
• Turn off the headphones and the docking station.
• Turn on both the headphones and the docking station. The
lights will initially blink fast, then they should turn on steady.
Listening to your digital wireless stereo
headphones
To listen through the headphones:
1 Turn on the headphones and docking station. Make sure
that your docking station and headphones are wirelessly
paired. See “Using the headphones” on page 14.
2 Set the headphone volume level to the minimum.
RF-WHP212_12-0593_MAN_V3.fm Page 15 Thursday, May 31, 2012 7:40 AM
To Next Page
Loading...
Need help?
General
