12
Connecting the wireless receiver to the power cord
To connect the wireless receiver to the power cord:
Note: Plug the power cord in only after all speakers are
connected to the wireless receiver.
1 Plug the small (female) end of the power cord into the AC
100V-240V~50/60Hz jack on the back of the wireless
receiver.
2 Plug the large (male) end of the power cord into a power
outlet.
100-240V~50/60Hz
Connecting the power cord
RF-WHTIB_13-0050_MAN_V1_ENG.fm Page 12 Tuesday, March 26, 2013 11:51 AM
To Next Page
Loading...
