28
Maintaining your system
Use a soft cloth dampened with a weak solution of mild detergent
and water. Dry the device immediately afterwards with a clean cloth.
Do not use abrasive cloth, thinners, alcohol, or other chemical
solvents, because they may damage the finish or remove the panel
lettering.
Cautions:
Do not block the ventilation openings.
If the power cord is damaged, it must be repaired by a qualified technician.
Troubleshooting
Check this information for a possible solution before calling for
assistance.
General troubleshooting
• Every Rocketboost network must contain only one hub device, which
helps other Rocketboost devices join the network.
• You can turn any Rocketboost wireless sender or wireless
sender/receiver into a hub by using the HUB STATUS or HUB ENABLE
switch on the back of the device. The network can only have one hub.
• The hub device must have power for the audio network to operate.
The hub can be in standby (power-saving mode), but must remain
plugged in.
• The existing hub device will be the device with the green power
indicator.
• The unobstructed operating range of a Rocketboost network is 150 feet
(45 meters).
• Each network must contain both a wireless sender device and a wireless
receiver device. Do you have both a wireless sender and a wireless
receiver device?
RF-RBWSO1_11-0202_MAN_V1.fm Page 28 Monday, May 2, 2011 11:46 AM
To Next Page
Loading...
Need help?
General
