17RF-RBWS02-01
• Repeat steps 1-5 for each additional Rocketboost device you are
adding to your network.
• The power indicators light steadily if the joining was successful.
• The power indicators blink slowly if the joining was not successful.
Note: Rocketboost devices have their own memory. After the devices are joined once,
they will remember each other and join automatically when your devices are
powered on again. Because of this, you can join all of your network components in
the same room before installing them in their permanent locations throughout the
house.
Listening to music
To listen to music:
1 Turn on the wireless sender and wireless speaker. The power indicator
LEDs should light steadily. If they are blinking you need to rejoin the
wireless sender/receiver and wireless speaker. See “Establishing
communication” on page 16.
2 Play music from the audio device connected to your wireless sender and
listen to it from the wireless speaker.
3 Adjust the volume level on your wireless speaker. If you have multiple
audio sources in your Rocketboost network, press the Source button on
the wireless speaker to hear the next audio source. Press the Source
button again to cycle through all available audio sources.
CHARGE
BASS
POWER/JOIN
CHANNEL
L - MONO - R
SOURCE
TM
Power on
indicator
RF-RBWSO2-01_11-0480 _MAN_V1.fm Page 17 Tuesday, May 24, 2011 3:42 PM
To Next Page
Loading...
Need help?
General
