25RF-RBWS02-01
Specifications
Wireless Speaker
Legal notices
FCC and IC Information:
This device complies with Part 15 of the FCC Rules and RSS-210 of the
IC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
Power supply (DC to AC adapter)
15 V, 1.5 A
Battery power
8 C cells (UM-2) (alkaline or NiMH)
Signal-to-noise ratio
90dBA +/-3dBA
Speaker impedance
Tweeter: 8 ohms
Woofer: 4 ohms
Rated output power (at 10% thd)
Tweeter: 5 W
Woofer: 22 W
Dimensions (W ×H × D)
15.83 × 9.13 × 9.13 inches
(402 × 210.8 × 210.8 mm)
Weight
99.5 oz.
(28.20 kg)
RF-RBWSO2-01_11-0480 _MAN_V1.fm Page 25 Tuesday, May 24, 2011 3:42 PM
To Next Page
Loading...
