Need help?Do you have a question about the Rockford Fosgate PUNCH 40 DSM and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power (4 Ohms) | 20W x 2 |
| Bridged RMS Power (4 Ohms) | 40W x 1 |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion (THD) | <0.05% |
Explains DSM technology, N-channel V-FETs, and upgraded power supplies for improved audio performance.
Details the cast aluminum heat sink, stealth mounting, and theft deterrence features of the new design.
Details IHF-202 standard power ratings at 14.4V battery voltage for mono and stereo loads.
Lists IASCA standard RMS power ratings at 11.6V battery voltage for various load conditions.
Covers Signal to Noise Ratio, Frequency Response, and Punch EQ specifications.
Provides technical specifications for the 60 Watt RMS two-channel power amplifier.
Provides technical specifications for the 100 Watt RMS two-channel power amplifier.
Provides technical specifications for the 200 Watt RMS two-channel power amplifier.
Features gold-plated terminals for reduced resistance in power, ground, and speaker connections.
Patented EQ compensates for car environment response errors, improving bass and high-frequency response.
Utilizes N-channel V-FETs for reduced distortion and improved sound quality.
Uses 90% discrete surface mount components for accurate sound reproduction with low noise.
Computerized protection circuits sense and reduce unsafe power levels, ensuring maximum output.
Double-sided plated through glass epoxy boards offer superior strength and rigidity.
Heavy-duty copper ground plane increases efficiency by lowering resistance in the power supply area.
Improved power supplies enhance transient response and provide more power.
Edge pin connector ensures higher reliability and supports factory testing to 100% specification.
Cast aluminum heat sink allows stealth mounting and acts as a theft deterrent.
To Next Page