Need help?Do you have a question about the Rockville Phenom RXD-M2 and is the answer not in the manual?
IC-controlled protection circuit monitors conditions, with LED indicators for status.
Covers Thermal, Speaker Short Circuit, Input Overload, and DC Offset protection.
Bridging a 4-channel amplifier for increased power output.
Configuration for using a 4-channel amplifier in a 3-channel setup.
Wiring and load configuration for the RXDM2 1-ohm mono amplifier.
Input and output connection details for the RXDM1 amplifier.
Speaker wiring diagram for the RXDM1 1-ohm mono amplifier.
Setup for bridging two amplifiers using the Master/Slave link.
Details on bridging RXDM4 amps for double power output into a 2-ohm load.
Wiring diagram illustrating the bridging of RXDM4 amplifiers.
Explains bridging load requirements and benefits of daisy-chaining amps.
Detailed power, frequency, and feature specifications for the RXH-F5.
Detailed power, frequency, and feature specifications for the RXA-F2.
Detailed power, frequency, and feature specifications for the RXA-F1.
Detailed power, frequency, and feature specifications for the RXA-T1.
Detailed power, frequency, and feature specifications for the RXA-T2.
Detailed power, frequency, and feature specifications for the RXD-M5.
Detailed power, frequency, and feature specifications for the RXD-M4.
General| Channels | 1 |
|---|---|
| Impedance | 2 Ohms |
| Minimum THD at RMS Power | <1% |
| S/N Ratio | >90dB |
| Damping Factor | >150 |
| Input Impedance | 10K Ohms |
| Crossover Range | 50Hz - 250Hz |
| Frequency Response | 10Hz - 180Hz |
| Input Sensitivity | 0.2V - 6V |
| Subsonic Filter | 50Hz |
| Bass Boost | 0 - 12dB @ 45Hz |
| Fuse Rating | 40A |
To Next Page