Need help?Do you have a question about the Rockville Phenom RXD-M4 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Minimum Speaker Impedance | 1 Ohm |
| Total Harmonic Distortion (THD) | <1% |
| Crossover Frequency | 50Hz - 250Hz |
| Bass Boost | 0 - 18dB |
| Bass Boost Frequency | 45Hz |
| Subsonic Filter | 10Hz - 50Hz |
| Phase Shift | 0 - 180 degrees |
| RMS Power Output @ 2 Ohms | 1500 Watts |
| Signal-to-Noise Ratio | 90dB |
| Input Sensitivity | 0.2V - 6V |
| Crossover Type | Low Pass |
IC controlled circuitry monitors conditions and protects the amp via LEDs.
Detailed explanation of Thermal, Input Overload, DC Offset, and Speaker Short Circuit protections.
Covers battery disconnection, wiring layout, mounting location, and safety precautions.
Explains power, ground, and remote connections, including fuse recommendations.
Guide on connecting two amplifiers in master/slave configuration and the bridging process.
Visual guide for wiring amplifiers in bridged mode.
To Next Page