Need help?Do you have a question about the Rockville Phenom RXA-F2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Signal to Noise Ratio | >90dB |
| Minimum THD at RMS Output | <0.05% |
| Input Sensitivity | 200mV - 6V |
| Low Pass Crossover Frequency | 50Hz - 250Hz |
| Subsonic Filter | 10Hz - 50Hz |
| Cooling | Fan Cooled |
| Frequency Response | 10Hz |
| Impedance | 2 Ohm |
| Crossover Filter | Low Pass |
| Bass Boost | 0dB |
| Phase Shift | 0-180 degrees |
| Damping Factor | >150 @ 100Hz |
Important safety guidelines regarding hearing damage and proper installation practices.
Details on IC-controlled circuitry, LED indicators, and diagnostic conditions.
Steps for setting input sensitivity, gain, and equalizer levels.
Instructions for connecting power, ground, and remote turn-on wires.
Diagram for a standard 4-channel speaker connection.
Diagram for bridging a 4-channel amplifier into 2 channels.
Diagram for configuring a 4-channel amplifier in a 3-channel system.
Wiring diagram for a 4-channel amp with mixed mono configuration.
Diagram for a 4-channel amp with dual mixed mono configuration.
Diagram for wiring speakers to a 5-channel amplifier.
Specifications and features of the RXD-M2 mono amplifier.
Specifications and features of the RXD-M1 mono amplifier.
Speaker wiring diagram for the RXD-M1 amplifier.
Instructions for bridging two RXD-M4 amplifiers.
To Next Page