Need help?Do you have a question about the Rockville dBM65 and is the answer not in the manual?
General| Impedance | 2 Ohms |
|---|---|
| Signal to Noise Ratio | >90dB |
| Low Pass Filter | 50 Hz - 250 Hz |
| Phase Shift | 0-180 Degrees |
| Fuse Rating | 30A |
| Input Impedance | 10k Ohms |
| Input Sensitivity | 200mV - 6V |
| Power Supply | 12V |
| Bass Boost | 0dB - 18dB |
| Frequency Response | 10Hz - 180Hz |
Critical warnings regarding hearing damage, electrical shock, and proper ventilation.
Explanation of protection features like thermal, short circuit, input overload, and DC offset.
Diagnosing and resolving issues causing the amplifier to enter protection mode.
Troubleshooting steps for when the amplifier won't power on or produce sound.
Identifying causes and solutions for audio clipping, distortion, and background noise.
Addressing problems like low output, blowing fuses, and excessive amplifier heat.
Resolving issues where the amp doesn't turn off or a specific channel is not working.
To Next Page