Need help?Do you have a question about the Rockville dBcomp Series and is the answer not in the manual?
Essential safety precautions and warnings for operating the amplifier.
Advises on potential hearing damage from high volume and traffic noise impairment.
Describes connecting two identical amps as Master/Slave for double power into a 2-ohm load.
Emphasizes connecting negative terminals with a wire strap to prevent amplifier damage.
Details IC-controlled protection, thermal, short circuit, overload, and DC offset protections.
Outlines power ratings, frequency response, S/N ratio, and physical dimensions for dBcomp4.
Outlines power ratings, frequency response, S/N ratio, and physical dimensions for dBcomp5.
Reiterates minimum impedance loads for single and bridged amplifiers to prevent damage.
Essential safety precautions and warnings for operating the amplifier.
Advises on potential hearing damage from high volume and traffic noise impairment.
Describes connecting two identical amps as Master/Slave for double power into a 2-ohm load.
Emphasizes connecting negative terminals with a wire strap to prevent amplifier damage.
Details IC-controlled protection, thermal, short circuit, overload, and DC offset protections.
Outlines power ratings, frequency response, S/N ratio, and physical dimensions for dBcomp4.
Outlines power ratings, frequency response, S/N ratio, and physical dimensions for dBcomp5.
Reiterates minimum impedance loads for single and bridged amplifiers to prevent damage.
General| Type | Compressor/Limiter |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| Inputs | 1 x XLR, 1 x 1/4" TRS |
| Outputs | 1 x XLR, 1 x 1/4" TRS |
| Sidechain I/O | 1/4" TRS |
| Ratio | 1:1 to ∞:1 |
| Input Sensitivity | +4dBu |
| Dimensions | 19" x 1.75" x 5.7" (483 x 44 x 146 mm) |
To Next Page
