Need help?Do you have a question about the Rockville dB55 and is the answer not in the manual?
General| Channels | 5 |
|---|---|
| S/N Ratio | >90dB |
| Input Sensitivity | 0.2V - 6V |
| Bass Boost | 0dB - 18dB @ 45Hz |
| Low Pass Filter | 50Hz - 250Hz |
| Minimum THD at RMS Output | <0.05% |
| Power Output | 1100W x 2 @ 2 Ohms |
| Impedance | 2 Ohms |
| THD | <0.05% |
| Crossover Range | 50Hz - 250Hz |
General safety instructions and warnings for amplifier installation and operation.
Warning about potential hearing loss from prolonged high volume usage.
Details the 45Hz peaking equalization circuit for bass boost up to 12dB.
Explains the use of Japanese studio-grade, high current Bi-Polar audio transistors.
Describes the IC-controlled protection circuitry, status LEDs, and protection modes.
Protects speakers from DC voltage via speaker terminals and amplifier malfunction.
Eliminates irritating speaker damaging turn-on and turn-off transients.
Details rated voltage, regulated voltage, and maximum input voltage limits.
Safety precautions and general advice for amplifier installation in a vehicle.
Guidance on securely mounting the amplifier with proper airflow and screw usage.
Explains the remote turn-on connection for powering the amplifier on/off.
Guidance on using correct fuse values and constructing a fused wiring harness.
Instructions for making secure power and ground connections to prevent overheating.
Step-by-step guide to setting crossover points, input sensitivity, and equalizers.
Details on using electronic crossovers, configurations, and subsonic filtering for optimal sound.
Guidance on connecting RCA cables and choosing quality interconnects.
Explains the function and adjustment of built-in low pass and high pass electronic crossovers.
Explains how to connect a 2-channel input to the 5-channel amplifier for mixed output.
Details connecting a 4-channel input to the 5-channel amplifier for fader control.
Describes connecting a 5-channel input to the 5-channel amplifier for independent subwoofer control.
Guides the setup for a basic 4-channel amplifier configuration using full range.
Instructions for bridging a 4-channel amplifier into two channels for subwoofers.
Explains wiring a 4-channel amplifier in a 3-channel mode with mixed crossovers.
Details a 4-channel amplifier configuration using mixed mono with passive crossovers.
Guides the setup for a dual mixed mono configuration using external crossovers.
Detailed specifications for the Rockville dB55 5-channel amplifier.
Detailed specifications for the Rockville dB45 amplifier.
Detailed specifications for the Rockville dB25 amplifier.
Detailed specifications for the Rockville dB16 amplifier.
Detailed specifications for the Rockville dB15 amplifier.
Detailed specifications for the Rockville dB14 amplifier.
Detailed specifications for the Rockville dB13 amplifier.
Detailed specifications for the Rockville dB12 amplifier.
Shows series wiring for dual voice coil speakers.
Shows parallel wiring for dual voice coil speakers.
Illustrates parallel wiring for two dual voice coil 2 ohm speakers.
To Next Page
