Need help?Do you have a question about the Rockville dB14 and is the answer not in the manual?
Essential safety precautions for using the amplifier to prevent injury or damage.
Explains the IC-controlled protection circuitry and status LEDs.
Guidance on wiring power and ground connections, including fuse recommendations.
Details on 2-ohm stable monoblock amplifiers and speaker connection options.
Diagram showing RCA preamp line outputs for multi-amp systems.
How to bridge two amplifiers together for increased power output.
Master/Slave setup diagram for twin amp bridging.
Important note and wiring diagram for connecting two amplifiers in a bridged configuration.
Explains speaker wiring configurations for dual voice coil speakers and impedance notes.
Essential safety precautions for using the amplifier to prevent injury or damage.
Explains the IC-controlled protection circuitry and status LEDs.
Guidance on wiring power and ground connections, including fuse recommendations.
Details on 2-ohm stable monoblock amplifiers and speaker connection options.
Diagram showing RCA preamp line outputs for multi-amp systems.
How to bridge two amplifiers together for increased power output.
Master/Slave setup diagram for twin amp bridging.
Important note and wiring diagram for connecting two amplifiers in a bridged configuration.
Explains speaker wiring configurations for dual voice coil speakers and impedance notes.
General| Channels | 1 |
|---|---|
| Frequency Response | 15Hz - 250Hz |
| Dimensions | 9" x 2.4" x 13" |
| S/N Ratio | >90dB |
| Input Impedance | 10K ohms |
| Crossover Slope | 12dB/octave |
| Signal to Noise Ratio | >90dB |
| Low Pass Filter | 50Hz - 250Hz |
| Phase Shift | 0-180 degrees |
| Input Voltage | 12V |
| Bass EQ | 0-12dB |
| Fuse Rating | 40A |
| Impedance | 2 Ohm |
| Input Sensitivity | 0.2V - 6V |
| Subsonic Filter | 15Hz - 50Hz |
| Bass Boost | 0-12dB at 45Hz |
| Weight | 7.7 lbs. |
| Damping Factor | >150 |
To Next Page
