Rockville dB14 User Manual

12
5 Channel Amp with 5 Channel Input
If your head unit has three pairs of RCA outputs, input Front Left and Front Right in to amplier Channels 1 and 2 input jacks. Rear Left and Rear Right in to ampliers Channels 3 and 4 input jacks.
Subwoofer output in to Channel 5. If your head unit has only a single subwoofer output, use a Y adaptor to feed both Channel 5 inputs. Set the Input Mode Switch to 5Ch. The ampliers preamp
circuitry will automatically mix all the channels and output will occur on all 5 channels. There will be Left and Right balance, Front to Rear Fader with independent subwoofer.
INPUT MODE SWITCH
IN 5CH POSITION
TO AUDIO OUTPUTS OF HEAD UNIT OR SIGNAL
PROCESSOR WITH STEREO OUTPUTS
SUBWOOFER OUT
L L
R R

Rockville dB14 Specifications

General

Channels	1
Frequency Response	15Hz - 250Hz
Dimensions	9" x 2.4" x 13"
S/N Ratio	>90dB
Input Impedance	10K ohms
Crossover Slope	12dB/octave
Signal to Noise Ratio	>90dB
Low Pass Filter	50Hz - 250Hz
Phase Shift	0-180 degrees
Input Voltage	12V
Bass EQ	0-12dB
Fuse Rating	40A
Impedance	2 Ohm
Input Sensitivity	0.2V - 6V
Subsonic Filter	15Hz - 50Hz
Bass Boost	0-12dB at 45Hz
Weight	7.7 lbs.
Damping Factor	>150