To Next PageTo Next PageHow to troubleshoot a Rockville Power Gig Speakers with no power?
If your Rockville Speakers have no power, ensure the unit is plugged in and the power switch is in the ON position. Also, check that the power cable is plugged in tightly. Inspect the fuse and replace it if needed. If these steps don't help, the power cable may be damaged; try using a different cable to check for shorts and immediately dispose of the original damaged cable.
What to do if my Rockville Speakers have no sound?
If your Rockville Speakers produce no sound, check that all the appropriate cables are correctly plugged in. Then, verify the Master Volume settings. Ensure the Volume and Gain of the appropriate channels are set above 0 and matched correctly. If you're using a microphone, make sure it's turned on. If you are using a mixing console, make sure the fader and balance are set to center positions and levels are increased.
General| Bluetooth | Yes |
|---|---|
| Built-in Amplifier | Yes |
| Impedance | 8 Ohms |
| Color | Black |
| Woofer Size | 15 inches |
| Peak Power | 2000 Watts |
| Inputs | XLR, 1/4", RCA |
| Outputs | XLR |
Scan QR codes or visit URLs for videos, owner's manual, and other important information.
Reduce risk of electric shock, avoid moisture, ensure ventilation, stable surface, and correct voltage.
Aim tweeter horns at ear level, avoid blocking them, use speaker stands for better dispersion.
Place microphones behind speakers, approach speakers from the rear for adjustments.
Use directional mics, avoid pointing mics at speakers, position mics correctly relative to monitors.
Use MASTER for volume after matching inputs. Use CLIP LED to avoid distortion.
Set source volume to 60%, Master volume to 75%, adjust Gain until CLIP LED lights or distortion occurs.
Connect mic to XLR or 1/4" jack, never both. Adjust levels as per 'Setting Level Controls'.
Connect stereo sources via XLR or RCA jacks, never both. Adjust levels as per 'Setting Level Controls'.
Connect mixer outputs to RPG Line In ports for larger venues. Set initial master/gain to 0.
Connect mixer outputs, switch on RPG, adjust mixer output and Gain to achieve proper volume.
Link RPG units using XLR or 1/4" TRS cables to Line In port. Use balanced line out for subwoofer.
Connect music sources (mixers, CD players) to LINE IN (XLR/RCA). Adjust Master Volume for proper volume.
Balanced connections minimize interference. Pin 1=ground, 2=hot, 3=cold. Bridge pins 1 & 3 for unbalanced.
Blue LED indicates musical output and proper function, not a clip indicator.
Lists all inputs, outputs, controls (volume, gain, EQ, etc.), indicators, and power features.
100W RMS, 50Hz-20kHz Freq. Response, 119dB Peak SPL, design highlights.
150W RMS, 45Hz-20kHz Freq. Response, 122dB Peak SPL, design highlights.
200W RMS, 40Hz-20kHz Freq. Response, 125dB Peak SPL, design highlights.
250W RMS, 35Hz-20kHz Freq. Response, 128dB Peak SPL, design highlights.
Step-by-step guide to safely replace a blown fuse using a screwdriver.
Check power connections, fuse, cables, volume, and gain settings for power or sound problems.
Ensure correct cable types (instrument, TS, TRS) are used for audio connections.
Point mics away from speakers and use correct input ports for better mic performance.
Verify correct source selection and audio file format for SD or USB playback issues.
Device complies with FCC Part 15. Avoid harmful interference by reorienting antennas or adjusting separation.
