Need help?Do you have a question about the Rockville RVA600.1 and is the answer not in the manual?
Warning about hearing loss from high volumes and impaired driving safety.
Describes the IC controlled protection and status LEDs for the amplifier.
Eliminates turn-on/turn-off transients for speaker protection.
Adjustable bass boost up to +12dB at 45Hz.
Covers High Level and RCA inputs for audio signal connection.
Filters low frequency noise from 10Hz to 50Hz.
Includes a dashboard bass remote control for adjusting bass levels.
Explains Thermal, Speaker Short, Input Overload, and DC Offset protection.
Connects the amplifier to the headunit's power antenna lead for auto on/off.
Disconnect battery, plan layout, mount securely, ensure airflow, avoid gas tank.
Covers RCA inputs, high-quality cables, and subsonic filter settings.
Procedure to set input sensitivity by adjusting the GAIN knob to prevent distortion.
Mount in a location with airflow using mounting tabs, avoid overtightening screws.
Includes fuse recommendations, red power wire gauge, and ground connection tips.
Details GND, REM, +12V, FUSE, and SPEAKER terminal locations and connections.
The amplifier is 4 ohm mono, final impedance must not fall below 4 ohms.
Connects to factory speaker wires, converting high voltage for the amplifier.
Automatically powers on via DC sense (High Level) or Radio Remote (RCA).
Lists key features, power output, dimensions, frequency response, and sensitivity.
To Next Page
General