44 Rockwell Automation Publication ENET-IN002H-EN-P - August 2017
Chapter 3 Install a 1769 EtherNet/IP Adapter
6. Before installing the replacement adapter, be sure that the bus lever on the
right-side adjacent module is in the unlocked (fully right) position.
7. Slide the replacement adapter into the open slot.
8. Connect the adapter and modules together by locking (fully left) the bus
levers on the right-side adjacent module.
9. Replace the mounting screws or snap the adapter onto the DIN rail.
10. Insert the Ethernet cable into the module.
11. Set the network address switches to the same value as the removed adapter.
To Next Page
Loading...
Need help?
General
