Need help?Do you have a question about the Rockwell Automation Allen-Bradley Compact 5000 and is the answer not in the manual?
General| Model | Compact 5000 |
|---|---|
| Communication Protocol | EtherNet/IP |
| Power Supply | 24V DC |
| Voltage Rating | 24V DC |
| Type | Adapter |
| Number of Ports | Varies by model |
| Product Type | Communication Adapter |
| Manufacturer | Rockwell Automation |
| Storage Temperature | -40°C to 85°C |
| Relative Humidity | 5% to 95% (non-condensing) |
| Certifications | CE, UL |
Details the EtherNet/IP features supported by the adapters, including communication rates and protocols.
Explains the security enhancement that restricts changes when I/O connections are active.
Details tasks that are prevented when the adapter is in Protected Mode.
Covers the use of SD cards for configuration storage on the 5069-AEN2TR adapter.
Describes how the adapter interacts with the SD card at power-up and when installed.
Explains how to connect external power supplies to the adapters using terminal blocks.
Details the system-side power supply requirements and limitations for the MOD power bus.
Describes the field-side power supply requirements and limitations for the SA power bus.
Provides guidance on calculating and tracking the SA power bus current draw per module.
Explains how to use the 5069-FPD to create new, isolated SA power buses.
Shows examples of using the 5069-FPD to create a second SA power bus.
Provides additional recommendations and notes regarding SA power usage and module behavior.
Explains the necessity and conditions for setting the adapter's IP address.
Details how to configure the IP address using the adapter's rotary switches.
Describes alternative methods like BOOTP/DHCP and RSLinx for setting the IP address.
Provides steps to reset the 5069-AENTR adapter to its factory default settings.
Explains how to reset the 5069-AEN2TR adapter using its reset button.
Guides on adding the adapter module to a controller project using Logix Designer.
Details setting the module's firmware revision and configuring electronic keying.
Covers setting the connection type and chassis size for the module.
Steps to set the project path and establish an online connection with the controller.
Explains how to set Ethernet port speed and duplex settings via Logix Designer.
Details setting domain name, host name, gateway address, and DNS server addresses.
Details the status indicators for the 5069-AENTR adapter and their meanings.
Lists and explains the status indicators for the 5069-AEN2TR adapter.
Lists and describes messages displayed on the adapter's 4-character display.
Describes the tags available for the Compact 5000 EtherNet/IP adapters.
To Next Page