Operating Temperature : 41 ~ 95 F - (5 ~ 35c)
Storage Temperature : -20~ 47 F - (-4 ~ 116 c)
Line Voltage : 100 ~ 240V AC
2. Operating Information
3. Hardware Requirements and Precautions
1. Both hard drives must be installed into the system for the device to work properly.
2. Only one interface connection may be used at once per computer system.
3. For the best performance of the system, it’s strongly recommended that you install hard
drives of the same model and if need be, replace faulty hard drives also with the same model.
If the same model of HDD is unobtainable, please replace with a model that is at least 20GB larger
in capacity.
4. All data on replacement hard drive will be erased once inserted into the system.
5. The actual usable storage capacity may dier from the stated capacity once the drives in the
systemhave been formatted.
6. Always safely dismount the volume from the Operating System before removing Rocpro U32.
from host computer
7. Do not remove the hard drive(s) while the system is powered on or switch the position of
the drives. Always remember to power o the unit prior to removing the hard drives
(unless hot-swapping for the purpose of a rebuild in a RAID 1 conguration).
8. In RAID 1 mode, only 1 hard disk failure is permitted. Please seek help from data recovery
services should there be further data-loss due to failures in a RAID 0 mode.
9. It is highly recommended for users to back up important data. Rocstor will not be responsible
for any lost of data caused during the use of the unit or the recovery of the data lost.
10. The default setting of ROCPRO™ U32 is RAID 1. To set it in a data protection mode, please set it
to RAID 1. Please set U32 to RAID 0 mode when speed and large storage capacity is required.
11. Users can set the RAID level and the basic functions of ROCPRO™ U32 using the buttons on
the right side of LCD screen in front of the product.
page 4 - 10ROCPRO™ U32 Series User Manual
To Next Page
Loading...
