Rocstor Rocpro U32 - System Temperature Overheat and Fan Failure Management; Additional Display Messages of System and Operation Procedures

8. System Temperature Overheat and Fan Failure Management
If during the rebuilding process, a drive malfunctions and is unable to continue the rebuilding process,
restart the U32 to check and see that the drive is in fact malfunctioning. If it is, please refer to chapter 6
“Hard Drive Replacement Instructions” to replace the malfunctioning drive.
Below are sample diagrams of drive malfunctioning.
Pri HDD : Fail
Sec HDD : OK
Pri HDD : OK
Sec HDD : Fail
Primary drive error during rebuild Secondary drive error during rebuild
Pri HDD : OK
Sec HDD : OK T
Pri HDD : OK F
Sec HDD : OK
System temperature exceeded limitation System fan malfunctioning
Note :
The next time you turn on the power of the unit, the system will automatically continue to
process the remains. Please do not switch position of the drive at any time.
If the LCD panel displays “T” on the bottom right hand corner meaning the system temperature has
exceeded its
allowance of 50
o
C or “F” at the top right hand corner meaning the system fan has malfunctioned and
the audio alarm alerts, you may rst press the MUTE button to disable the audio alarm. At the allowed
operational state, re-start the system to double check and see if the problem is still present. If the
problem persists, please turn o the system and contact ROCSTOR tech support for further assistance.
9. Additional Display Messages of System and Operation
Procedurest
System Temp.
50
o
C
System FAN
xxxx RPM
System temperature message System fan RPM message
If the LCD panel displays “T” on the bottom right hand corner meaning the system temperature has
exceeded its allowance of 50
o
C or “F” at the top right hand corner meaning the system fan has
malfunctioned and the audio alarm alerts, you may rst press the MUTE button to disable the audio
alarm. At the allowed operational state, re-start the system to double check and see if the problem is
still present. If the problem persists, please turn o the system and contact ROCSTOR tech support for
further assistance.
page 8 - 10ROCPRO™ U32 Series User Manual