RODE Microphones VideoMic Quick Start Guide

8
0
H
z
VideoMic
TM
Parts Guide
Mic Controls
quickstart
guide
VideoMic
TM
www.rodemic.com
1. Foam windshield
2. Camera shoe mount
3. Battery cover
4. PAD switch (inside battery compartment)
warranty.rodemic.com/videomic
Scan the QR code to
register now, or visit
Don’t FORGET
to register for your
FREE ten year warranty!
The RØDE VideoMic
TM
features an integrated
shock mount based on Rycote
®
Lyre
®
technology.
Constructed from a single piece of hard-wearing
thermoplastic, the Lyre
®
provides superior acoustic
suspension to traditional elastic solutions,
and will never wear out, sag or snap.
RØDE SOUNDBOOTH
now for Broadcast mics
Hear and compare RØDE microphones
at www.rodemic.com/soundbooth or on your iPad
®
5. LED power indicator
6. Power and HPF switch
7. Integrated Rycote
®
Lyre
®
suspension
8. 3.5mm dual mono output cable
The High Pass Filter (HPF ) is a low frequency cut-off setting, which you can use
to remove rumble, camera noise or other low frequency noise while recording.
Mic ON
using High Pass Filter
Mic ON
Flat setting
Battery OFF
Mic mute
6
7
8
LED power
indicator
028_952_1_Videomic_Quickstart.indd 1028_952_1_Videomic_Quickstart.indd 1 17/12/2012 8:45:19 AM17/12/2012 8:45:19 AM

RODE Microphones VideoMic Specifications

General

Frequency Response	40Hz - 20kHz
Max SPL	134dB SPL
Equivalent Noise Level (A-weighted)	20dBA
Output Impedance	200Ω
Output Connection	3.5mm
Power	1.5V AA battery or phantom power (11-48V)
Battery Life	100 hours
Type	Shotgun Microphone