Roger Technology H70/200AC - Page 28

H70/200AC
28
n5 Serial number
00-99 → 3° progressive number
n6 Serial number
00-99 → software version
o0 Movements number
00-99 → X 10.000 movements
o1 Movements number
00-99 → X 100 movements
h0 Motor activation hours
00-99 → X 100 hours
h1 Motor activation hours
00-99 → hours
d0 Power on in days of control unit
00-99 → X 100 days
d1 Power on in days of control unit
00-99 → days
P1 Password P1
00-FF
00
P2 Password P2
00-FF
00
P3 Password P3
00-FF
00
P4 Password P4
00-FF
00
CP Change password
If You ll in a password to protect the data memorized, these datas can be changed only if You know the
password. The steps to ll in the password are the following:
• Change the value of the parameter P1, P2, P3, P4
• Showing on display the parameter “CP”: push togheter the buttons “+” and “-“ for 4 sec. When the display
blinking the password is memorized