Roger Technology H70/104AC - User Manual

Quick Start H70/104-105AC
Rev01 17/08/2020
ROGER TECHNOLOGY
Via S. Botticelli 8 • 31021 Bonisiolo di Mogliano Veneto (TV) • ITALIA
P.IVA 01612340263 • Tel. +39 041.5937023 • Fax. +39 041.5937024
info@rogertechnology.com • www.rogertechnology.com
A
Power supply H07RN-F 3x1,5 mm
2
double insulated cable
1
Photocell - Receiver 4x0,5 mm
2
double insulated cable (max.20 m)
2
Photocell - Transmitter 2x0,5 mm
2
double insulated cable (max.20 m)
3
Flashing lamp unit 2x1 mm
2
double insulated cable (max.10 m)
4
Antenna RG58 50 Ohm cable for external use (max.10 m)
5
Selector / Keypad Cavo 3x0,5 mm
2
cable (max.20 m)
1. Typical installation
H70/104-105AC is the range of 230V AC digital controllers installed with the M30, H30, R30, G30 and E30 product series for
sliding gate applications.
EN
1
A
1
5
2
2
3
4

Roger Technology H70/104AC Specifications

General

Model	H70/104AC
Category	Control Unit
Frequency	50/60 Hz
Output Voltage	24 Vdc
Power	70 W

Summary

Typical Installation

Electrical Connections

Connection with 1 Pair of Photocell

Details wiring for a pair of photocells for safety and control.

Connection with Flashing Light

Describes how to connect a flashing indicator light to the system.

Pre-Installation Checks

Self-Acquisition Procedures

Acquisition with Encoder and Limit Switches

Guides self-acquisition with encoder and optional limit switches.

Acquisition with Limit Switches Only

Outlines self-acquisition using limit switches without an encoder.

Acquisition without Encoder or Limit Switches

Explains self-acquisition without using encoder or limit switches.

Basic Parameter Settings

Programming a New Transmitter

Copying an Existing Transmitter