Roger Technology H70/200AC - User Manual

2
2
3
4
1
A
A
5
1
Quick Start H70/200AC
Rev01 20/08/2020
ROGER TECHNOLOGY
Via S. Botticelli 8 • 31021 Bonisiolo di Mogliano Veneto (TV) • ITALIA
P.IVA 01612340263 • Tel. +39 041.5937023 • Fax. +39 041.5937024
info@rogertechnology.com • www.rogertechnology.com
A
Power supply H70/200AC - Motors 3x1,5 mm
2
double insulated cable (max.15 m) - 3x2,5 mm
2
(max. 30 m)
1
Photocell - Receiver 4x0,5 mm
2
double insulated cable (max.20 m)
2
Photocell - Transmitter 2x0,5 mm
2
double insulated cable (max.20 m)
3
Flashing lamp unit 2x1 mm
2
double insulated cable (max.10 m)
4
Antenna RG58 50 Ohm cable for external use (max.10 m)
5
Selector / Keypad Cavo 3x0,5 mm
2
cable (max.20 m)
1. Typical installation
H70/200AC is a range of 230V AC controllers and controls automations for gates with 1 or 2 asynchronous single phase ROGER
motors.
EN

Roger Technology H70/200AC Specifications

General

Maximum Motor Power	200W
Operating Temperature	-20°C to +55°C
Protection Level	IP54
Input Voltage	230V AC
Output Voltage	24V DC
Motor Supply Voltage	230V AC
Protection	Overload

Summary

Typical Installation

Electrical Connections

Before Starting

Acquisition Procedure

Acquisition Procedure (Without Encoder, With 2 Limit Switches)

Step-by-step guide for gate acquisition without encoder using two limit switches.

Acquisition Procedure (Without Encoder, Opening Limit Switch Only)

Procedure for gate acquisition without encoder using only the opening limit switch.

Acquisition Procedure (Without Encoder, No Limit Switches)

Guide for gate acquisition without encoder and without electric or magnetic limit switches.

Setting Basic Parameters

Programming a NEW Transmitter

Copying a Transmitter