Roger Technology B70/1DCHP User Manual

Quick Start B70/1DCHP
Rev02 03/04/2020
ROGER TECHNOLOGY
Via S. Botticelli 8 • 31021 Bonisiolo di Mogliano Veneto (TV) • ITALIA
P.IVA 01612340263 • Tel. +39 041.5937023 • Fax. +39 041.5937024
info@rogertechnology.com • www.rogertechnology.com
A
Power supply H07RN-F 3x1,5 mm
2
double insulated cable
1
Photocell - Receiver 5x0,5 mm
2
double insulated cable (max. 20 m)
2
Photocell - Transmitter 3x0,5 mm
2
double insulated cable (max. 20 m)
3
Flashing lamp unit 2x1 mm
2
double insulated cable (max. 10 m)
4
Antenna RG58 50 Ohm cable for external use (max. 10 m)
5
Selector / Keypad 3x0,5 mm
2
cable (max. 20 m)
1. Typical installation
B70/1DCHP is the range of 36V DC digital controllers installed with the BG30 product series for sliding gate applications.
EN
1
A
1
5
2
2
3
4

Roger Technology B70/1DCHP Specifications

General

Brand	Roger Technology
Model	B70/1DCHP
Category	Control Unit
Language	English

Summary

Typical Installation

Electrical Connections

Display Functions and Settings

Before Starting Setup

Automation System Model Selection

Select the automation system model installed using parameter A1.

Motor Position Configuration

Set the motor position relative to the gate using parameter 71.

Limitswitch Adjustment Procedure

Adjust mechanical or magnetic limit switches to stop the gate correctly.

Gate Closing and Test Button Verification

Verify gate closing and TEST button response for FC message.

Test Button Operation and Safety Messages

Press TEST button and check for possible alarms and safety device messages.

Acquisition Procedure

Setting Basic Parameters

Speed and Movement Dynamics

Configure speed, approach, deceleration, acceleration, and boost settings.

Motor Torque Settings

Set minimum and maximum motor torque values.

Obstacle Detection and Safety Settings

Adjust obstacle detection sensitivity and reverse time for safety.

Programming a New Transmitter

Copying a Transmitter

Photocell Grounding Connection