Need help?Do you have a question about the Rohde & Schwarz EK 896 and is the answer not in the manual?
General| IF Rejection | > 80 dB |
|---|---|
| Image Rejection | > 80 dB |
| Frequency Resolution | 10 Hz |
| IF frequencies | 455 kHz |
| Input Impedance | 50 ohms |
| IF Bandwidth | 6 kHz |
| Demodulation Modes | AM, CW, SSB |
| Power Supply | 50/60 Hz |
Explains the scope and content of the operator manual for VLF-HF Receivers EK 895 and EK 896.
Describes the built-in test procedure for checking receiver modules and paths.
Explains the automatic monitoring of equipment functions and error reporting.
Details operation using Control Unit 2 (EK 895 LOCAL or EK 896), covering general settings and functions.
Describes the operation of the EK 895 receiver using Control Unit 1 in REMOTE mode.
Details the control and display elements for Control Unit 2, covering both EK 895 and EK 896.
Details the control and display elements for Control Unit 1 in REMOTE mode for the EK 895.
Explains the command format and syntax for remote control operations.
Describes the two operating modes: MANUAL and CHANNEL for remote control.
Covers setting frequency and modulation mode via remote commands.
Details remote commands for special functions like channel call-up and preamplifier control.
Explains system functions and commands available for remote control.
To Next Page
